PDA

View Full Version : Problem with bcd3000



notroubleclubber
24-02-2010, 08:15 AM
Since ive bought my behringer bcd3000 from ebay ive had problems with some of the controls. Some of them tend to pop and think need replacing.

Mainly the master vol control and the headphones mix knobs. They dont crackle but instead of going smoothly when rotating they either go one or the other.

Would switch cleaner help? If not, could i just go to maplins and get a couple of potentiometers and get them soldered in instead?

I dont want to get rid of it as its a great unit and this is the only probs ive had with it.

Squelch
03-05-2010, 10:35 AM
I have borrowed one of these but I have had trouble with it as well.The microphone part doesn't work and it freezes my vdj.Shame though,it does seem like it would be a good bit of kit if it was working ok:(

notroubleclubber
03-05-2010, 10:43 AM
Never used the mic part as always plug the mic into the mixer the bcd is plugged into.
With regards to the problem above: i have since cleaned all the contacts on all the switches but have yet to try it to see if it has made any difference.