PDA

View Full Version : Pipe & Base stands (starcloth / drape stands)



Danno13
03-05-2011, 02:53 PM
Ok, got a bit of this that I need to shift. I appreciate it's perhaps a bit specialist for most, but thought I'd try here before paying to list anywhere else.

If you've not seen this in use before, basically its the standard way of rigging starcloths, drapes, blackout cloths etc. flat against walls. No tripod legs and you rig everything at ground level and then just push up to the roof, it really is such a good system.

All of this is brand new, perhaps with a couple of marks where I've checked it over, but never actually been used out of the road. Items as follows -


6 x TS 614 (6ft - 14ft extenable stopping anywhere inbetween) upright peices - £66 each

6 x 18" x 18" Galvanized steel base plates with 1 fixing point in the centre, and three on one side (left corner, middle, right corner) allowing you to poisition it right up against stages, or wall - £42 each for these

6 x Spigot pins (you screw this to the base, then slot the upright over) - £12 each

5 x TDS712 cross-peices @ £30 each

Carry bag (which would hold all the pole above, but obviously not the bases) - £65


All poles made by Innovative - http://www.innovative-sys.com/ Bases were done by a metal fabricator in the UK
I've attached a photo of this in use (although not the same stuff that's for sale) to demonstrate what it is incase anyone didn't know. You may recognise the location from last nights Gadget show :D

If anyone wants any closeup photos, please let me know and I can take some when I'm next at the lockup.

Danno13
04-05-2011, 11:12 PM
All sold. :)