PDA

View Full Version : behringer cx2310


gillo
02-12-2006, 07:16 PM
ive just bought a brand new behringer crossover for 52 pound what leads do i need to ennect it to two amps and where is the cheapest place i an get these from :)
soundlad
02-12-2006, 07:51 PM
what input connections are on the back of your amp? 1/4jack, phono, xlr??
gillo
02-12-2006, 08:13 PM
what input connections are on the back of your amp? 1/4jack, phono, xlr??

jak and phono
gillo
02-12-2006, 08:16 PM
would i need 4 of these
http://cgi.ebay.co.uk/2-X-6M-MIC-LEAD-XLR-TO-JACK_W0QQitemZ230059667793QQihZ013QQcategoryZ23783 QQrdZ1QQcmdZViewItem
TonyB
02-12-2006, 11:04 PM
would i need 4 of these
http://cgi.ebay.co.uk/2-X-6M-MIC-LEAD-XLR-TO-JACK_W0QQitemZ230059667793QQihZ013QQcategoryZ23783 QQrdZ1QQcmdZViewItem

Probably not. The jacks are mono (tr) you would be better getting balance leads with TRS jacks like http://cgi.ebay.co.uk/Balanced-Mic-Lead-XLR-Female-to-TRS-Jack-Black-6m_W0QQitemZ290055901298QQihZ019QQcategoryZ23783QQ ssPageNameZWDVWQQrdZ1QQcmdZViewItem but do you need them 6m long? I use 1m leads XLR to TRS leads.
soundlad
03-12-2006, 08:15 AM
i had a behringer eq and the outputs from that are 1/4 jack & xlr. So you would be better off with balenced xlr to xlr! Can't remember if they were male or female!
DMX Will
03-12-2006, 09:54 AM
i had a behringer eq and the outputs from that are 1/4 jack & xlr. So you would be better off with balenced xlr to xlr! Can't remember if they were male or female!

As standard:

All XLR sockets on equipment (outputs) are Male and inputs are female. The opposite to DMX I might add (Male In), Female Out.
TonyB
03-12-2006, 03:52 PM
i had a behringer eq and the outputs from that are 1/4 jack & xlr. So you would be better off with balenced xlr to xlr! Can't remember if they were male or female!

1/4 TRS jacks are balanced. You can tell if it is a balanced jack or not by slowly pushing in a jack plug. If you feel two "notches" it is balanced but if you feel one (like on a speaker jack) it is not. Balanced 1/4" jacks use the stereo headphone type jack plug.

Behringer 1/4" jacks are balanced but you can use either TR (unbalanced) or TRS (balanced) jack plugs in them.
soundlad
03-12-2006, 04:32 PM
1/4 TRS jacks are balanced. You can tell if it is a balanced jack or not by slowly pushing in a jack plug. If you feel two "notches" it is balanced but if you feel one (like on a speaker jack) it is not. Balanced 1/4" jacks use the stereo headphone type jack plug.

Behringer 1/4" jacks are balanced but you can use either TR (unbalanced) or TRS (balanced) jack plugs in them.

Look out for two black bands on the tip if the jack that's stereo worded a bit different!!!:D :D :D