Our website is made possible by displaying online advertisements to our visitors.
Please consider supporting us by disabling your ad blocker.
-
Kam laser fscan 40 - not working
Hi, I am hoping that one of you gurus may be able to lend me some advice.
I have a Kam laser fscan 40, which has been working fine up until today.
For some reason it is just stuck on a single pattern and not operating properly in the sound to light mode.
I have the the dips set as below:-
All dips are off except for dip 10 - this is how it says to switch on the sound to light mode in the manual.
I don't think I have knocked it at all and it is stored in a case so I can't see why it has gone wrong.
Can anyone give me any advice before I send for repair, just in case it is something silly.
Many Thanks
Nathan
-
This might seem obvious, but has the mic sensitivity knob been turned up high enough?
-
Yeah unfortunately, I have tried it at min, max and in the middle, but no difference - thanks though this is the kind of thing I am hoping it could be.
-
Perhaps the solder/wire has come loose on the on board mic? It's worth opening it up and having a little look.
-
Good thinking I will see if I can take a look although I am not very tetchy at that sort of thing - thanks
-
I had a similar problem with this laser a while back.
Could be a broken motor.
Check if its under warranty before you open it up.
-
I think it may be the same for me as there is a mirror inside that looks like it should be moving, but isn't.
Did you get the motor fixed?
-
In my case it was under warranty and I got it replaced with a different product.
Sorry for not being much help.
Hopefully someone on here will have a better idea on fixing it.
-
I might be lucky as I purchased extended cover when I bought it :-)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules