Our website is made possible by displaying online advertisements to our visitors.
Please consider supporting us by disabling your ad blocker.
-
-
-
If you can disconnect the power input from the lamp ballast, do so. It'll make working with the case open & powered much safer.
-
-
Its very easy to do it the wrong way round, even when you have checked.
They tend to mix up the wires and colours, so you have to look at the board also.
Great when it all works though.
Last edited by yourdj; 05-05-2016 at 08:09 PM.
-
Originally Posted by
yourdj
This is my system now (I have been through al manner of systems now).
I looked at the ADJ unit and prefer this one for various reasons.
I used to use sender boxes, but find that just using the light as a master in the booth is easier now. Its basically what you see below. That sends the signal to all the other lights. Not had a problem with range (better than the sender boxes) but I have a larger arial is required. Marquees, for example. The little router for example only stretches about 10 metres clear space, so you could opt for a box router if you want to control it from a distance from the cutey box.
All you need is:
1: Cuety box: £220
2: router: £20
3: iPad & sender/light.
I have put a wireless receiver in one of my bar lights, there is a separate thread on that.
Newbie Post.....found this video very informative, thanks
-
5v... where?
Sorry to drag up an old post, but I'm trying to retrofit 8 adj megatripar profile pluses and wondered if you managed to give a 5v rail and if you had a picture of it?
I'd be very grateful for some simple pointers.
Jon
-
I might just have a photo which'll help somewhere.. I've already done some investigation of the same mod for a friend...
-
Thanks.
I totally dismantled one yesterday and there's a perfect spot for the wireless pcb. The aerial is less obvious but think I have a workable solution. Dmx is buried on the lower board but still easy enough to get to.
Just need power!
-
Dinosaur
Originally Posted by
jonb67
Sorry to drag up an old post, but I'm trying to retrofit 8 adj megatripar profile pluses and wondered if you managed to give a 5v rail and if you had a picture of it?
I'd be very grateful for some simple pointers.
Jon
Hello Jon.
Sorry, I'm not knowledgeable enough to help with your quest, but welcome along to the Forum, and could I ask you to pop across to the Newbies section and say hello. We're a nosey lot, and like to know who we're typing to. Thanks.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules