PDA

View Full Version : Yamaha stagepass 300/500


wayne1983
08-01-2008, 07:08 PM
Id like to know if you needed to can you link them together to make a bigger system. Also can you link a 300 and 500 together, or as it got to be just 300-300 and 500-500, cheers.:)
Corabar Steve
08-01-2008, 10:31 PM
I'm sure there is something in the manual about linking them (jack socket 5 to jack socket 7 on the next in line I think)

http://www2.yamaha.co.jp/manual/pdf/pa/english/mixers/stagepas300_en_om.pdf
wayne1983
09-01-2008, 08:58 AM
I'm sure there is something in the manual about linking them (jack socket 5 to jack socket 7 on the next in line I think)

http://www2.yamaha.co.jp/manual/pdf/pa/english/mixers/stagepas300_en_om.pdf


Ok thanks, just wondered thats all.:)
djsteve10
09-01-2008, 09:22 AM
Not something i know about but im sure Daz has something similar?
Corabar Steve
09-01-2008, 09:49 AM
I can't fint the manual for ours, but I'm sure it is possible by the method I described above (just watch your gain on the second set)
wayne1983
09-01-2008, 10:16 AM
I can't fint the manual for ours, but I'm sure it is possible by the method I described above (just watch your gain on the second set)

Really, does it make a big difference?:)
Corabar Steve
09-01-2008, 10:24 AM
Not sure, but you don't want to be feeding a clipped or distorted signal into it do you. Depends on the output level from socket 5. Although it says you can send a signal to powered speakers, I would assume you would treat it just like sending a signal from any other mixer to say a set of powered Mackies (in effect the amp in the Stage Pas mixer doing the same job as the amp in the speaker).