Dynatwins & ImpossibLED

[mikejburrett]

I do not usually worry too much about DMX and have only ever had a maximum of two compatible lights that I have just linked together.
I now have a couple of Dynatwins and an ImpossibLED - I have been informed that I can link them all together, but how? :bang:

[mikejburrett]

I am aware how to connect two identical lights together via DMX cable, and have a CA-8 which I use, but I want to know how to connect 2x Dynatwins and 1x ImpossibLED in a similar way to the following diagram.
I understand that it may be achieved by setting the dip-switches in some way? However there aren't any on the ImpossibLED.

[Vectis]

I am aware how to connect two identical lights together via DMX cable, and have a CA-8 which I use, but I want to know how to connect 2x Dynatwins and 1x ImpossibLED in a similar way to the following diagram.
I understand that it may be achieved by setting the dip-switches in some way? However there aren't any on the ImpossibLED.

Most unlikely to work.

When the CA8 is plugged into the first dynatwin, the DMX ports then act in a 'Master/Slave' arrangement and not pure DMX. Unless the ImpossibLED can interact with the master/slave signals being broadcast from your first dynatwin, you're onto a loser.

DMX isn't difficult but it's the way to go.