PDA

View Full Version : Replacement t-Bar Bracket


AnthonyG
30-12-2009, 04:52 PM
Hey folks.. My cheapo (maplins) t-Bar failed tuther day. It wasn't overload (nothing on it at the time), it fell over whilst loading up to leave... and broke the T element that attached the vertical to the horizontal.. I've measured the diameter ant is about 37mm round..

Anyway.. i need a new replacement part.. Does anyone know of where i could source one...

Cheers, Ant:(
ppentertainments
30-12-2009, 05:00 PM
TBH a new maplins one will probably as cheap as parts. I would consider upgrading though.
AnthonyG
30-12-2009, 05:02 PM
OK but this is a great backup.... Where could i get one from from...??
Excalibur
30-12-2009, 05:10 PM
OK but this is a great backup.... Where could i get one from from...??

Me. I've got a few spare. Long story. PM me your address, and I'll post a couple. Only little plastic bits, so shouldn't be an arm and a leg.
AnthonyG
30-12-2009, 05:46 PM
PM sent - Thanks!
nisfo
30-12-2009, 05:57 PM
Hi Anthony,
If Excalibur can't help. I have a few metal skytec t-bars that Crazy K came over to look at. They wouldn't fit his tripod so had some trussing off me instead. They have 35mm fittings and were part of a par can set so are surplus.
AnthonyG
30-12-2009, 06:10 PM
Nisfo - Always interested - Excalibur is sticking them in the post, so will see how they fair.

I'll come back to you if thats ok...
nisfo
30-12-2009, 06:13 PM
Thats fine mate, always here to help.

If I remember rightly you were after lighting in need of repair. I had a job lot come in, problems vary from motor failure to bulb holder failure.
AnthonyG
30-12-2009, 06:27 PM
Sounds like i need to pop over to staffs and help you out!!

PM me some dates...