Best Clamp To Use For Acme Dynamos

[notroubleclubber]

Ive managed to get hold of 4 acme dynamos which are going to be my main lighting with a vasto either end. Ive always used standard disco lighting g clamps for the vastos but was windering what to use for the acme dynamos?

Ive seen around some quick release clamps - are these any good.
Im going to prewire my deckstand with bar above my head type system (think it was made by rhino) and the top bar is measuring square at 38-39mm (tape measure is a bit old!)per side.

[OllieJames]

I would just use G-clamps. I did for when I had my Dynamos.

[Shakermaker Promotions]

I used to use G Clamps for my Dynamos but then started using the wingnuts and bolts and using the holes on the T-Bar.

[Booche]

I used to use G Clamps for my Dynamos but then started using the wingnuts and bolts and using the holes on the T-Bar.

Same as me :) i bolt them direct to the frame that way it gives you the height

Cheers Dave :)

[Excalibur]

Same as me :) i bolt them direct to the frame that way it gives you the height

Cheers Dave :)

Not for me, I'm afraid. Try that with a Magic Moon. ;) :eek: :eek: :eek: Need two folk to hold it while you put the bolts in.

[Dynamic Entertainment]

I use G clamps, but have use the plastic O clamps before :)

[welby]

I would just use G-clamps. I did for when I had my Dynamos.

I use G-clamps for my dynamos - very quick to get on the top bar.

What are you running now Ollie?