Behringer mixer fx problem

[salford1986]

Hello iv got a behringer 1204fx mixer the first 5 times of using it, it was great no when I use it the fx wont work on any channels and any fx setting. It must be a button I pressed or something. But when I turn the volume on the fx up then the fx volume on the channel fx the noise signal registers at the side of the fx settings. Any suggestion. I have the fx volume up and the channel fx turned up like I said it used to work perfect now it don't.

Thanks guys

[Glenski]

Hello iv got a behringer 1204fx mixer the first 5 times of using it, it was great no when I use it the fx wont work on any channels and any fx setting. It must be a button I pressed or something. But when I turn the volume on the fx up then the fx volume on the channel fx the noise signal registers at the side of the fx settings. Any suggestion. I have the fx volume up and the channel fx turned up like I said it used to work perfect now it don't.

Thanks guys

Hello

On my Behringer Europower PMP 1680S i have an FX on/off switch ... have you set this to off by mistake ? does yours have this switch [should be grey and located next to the FX engine module]

Thanks

Glenn

[Paul James Promotions]

If it's this older mixer version, there are 3 dials and 1 button that effect the FX output.

1. FX dial on each channel.
2. FX send.
3. FX return.
4. Routing button (this routes to either the Main Outputs or the Sub Outs).

Have a play.

[Digitalsounds]

Or

Have you accidently pluged your headphones into the FX Footswitch by mistake, as this some times puts the FX into OFF Mode you might see a flashing dot on the lcd display this is an indicator of this, just plugthem in again and pull it out this might be your problem.

[salford1986]

No I Avnet been using my headphone, I'm starting work abit earlier tonight so il have a look and get back to you