martin wizard extreme / mc1 controller users advice needed

[flatliners]

i have been inside the unit and moved the little black thing from 1 pin to 2.
my question is does anyone know what dip switch settings i should have the wizards set to for the mc1 controller and would both wizards be same settings.
can anyone help thanx

[Solitaire Events Ltd]

From the manual...

M C - 1 S E T T I N G S
To control a Wizard Extreme using a Martin MC-1 controller, DIP-switch
pin 10 must be set to OFF. The Wizard Extreme must also be set to
Wizard emulation 8-channel mode by moving a jumper on the circuit
board. This procedure is described in “Setting Wizard emulation and 1-
channel modes” on page 32. Changes to these settings do not take effect
until the fixture has been powered off and on.
DIP-switch pins 6, 7, 8, and 9 provide special options that are most useful
when operating multiple Wizard Extremes from a single MC-1. Fixtures
with these options selected will respond to the same commands but react
differently than Wizard Extremes with standard settings. This allows you to
make a light show more diverse but retain synchronized control of your
fixtures.

Go here and to page 20 (http://www.lichtpunt.nl/upload/documenten/Wizard%20Extreme.pdf)

[flatliners]

Thank you Darren