PDA

View Full Version : Denon MC6000 - Listening Problems



ian8limelight
30-10-2013, 06:04 PM
Hi All,

A friend of mine has been having problems with not being able to hear the individual loaded tracks on any deck using the headphone facilities. He can hear the master output but not the individual decks.

Any ideas please?

Kind regards,


Ian.

djdj
31-10-2013, 01:03 PM
I would say he needs to check it's set up ok
there are two options
2 deck & 4 Deck
Check which he is using and config as per this;
4 deck internal software mixer configruation:

For 4 deck software mixing using the software mixer built into VirtualDJ via all 4 channel sliders, set the following:



Set the switch on back of DN-MC6000 to PC MIX


Select MIDI as the source for each channel.


Press CF Mode to choose both AUDIO and VIDEO (Or if you prefer to use the crossfader for video only, choose VIDEO.)


In VirtualDJ, go to CONFIG -> Sound Setup and set your sound settings as follows:

Inputs: Line INs
Outputs: Headphones (Master: Chan 1&2 / Headphones: Chan 3&4)
Sound card: ASIO -> Denon ASIO Driver (Mac: 4-out card -> DN-MC6000)


Click APPLY


2 deck external hardware mixer configruation:

For 2 deck (Left/right) hardware audio mixing using the hardware mixing capabilities of the DN-MC6000 via the middle two channels, set the following:



Set the switch on back of DN-MC6000 to INT MIX


Select USB/MIDI as the source for the middle two channels.


Press CF Mode to choose VIDEO.

IMPORTANT: Make sure that the AUDIO light is off, otherwise you will also control the internal software mixer of VirtualDJ and will not be able to headphone pre-listen from the MC6000. This is because the audio is faded out by VirtualDJ before it reaches the sound card of the MC6000 and its hardware mixer. Make sure that the software crossfader in VirtualDJ is always in the centre.

Alternatively, in VirtualDJ Pro you can disable the software audio crossfader in VirtualDJ itself by going to CONFIG -> Options and setting Crossfader to Disabled.


In VirtualDJ, go to CONFIG -> Sound Setup and set your sound settings as follows:

Inputs: Line INs
Outputs: External Mixer
Sound card: ASIO -> Denon ASIO Driver (Mac: 4-out card -> DN-MC6000)


Click APPLY