Slaving amplifiers

[Muzikmania]

I have a Behringer EP4000 amplifier and am wanting to link this with a Prosound 1000 watt amplifier, however my behringer amp (as shown in image) only has input 1 and imput 2 for jack and XLR.. there are no outputs. I am wanting to do this so as i can power my speakers with one amp and my friends speakers with the other.

How is this possible??

If anyon3 can explain how i can do this id appreciate it?
I am wanting to still run two seperate channels for either side (stereo mode)

Thanks..

[Excalibur]

Just going off to read the manual to check, but it should be simple. Back soon.

I'm back. As far as I know, this is a question I asked many years ago, and the solution is simple. The EP4000 has XLR and Jack inputs. What you must never do is to connect both of these to the outputs of mixers at the same time. However, since these connectors are linked, ( and balanced ) connect your EP4000 up as normal, using one set of sockets, and connect the other set of input sockets from the EP4000 to the inputs of the Legendary Prosound.

Alternatively, get splitter cables, ie XLR to 2XLR.

That's the answer to your question, but in all honesty, it's probably a total waste of time, as you'll get little discernible increase in sound output.